Регулятор температуры и влажности. Идеально подходит для самодельных инкубаторов.
Так же применяется в местах где нужно задать температуру и влажность: инкубаторы, брудеры, теплицы, подвалы для хранения овощей, склады.
Operation steps:
Long times press setting key for 3 seconds to enter the parameter setting menu, set the following:
1. Start temperature settings "S01" value, and setting plus or minus (shift function) into the settings, press the function key to complete (such as setting 23.4degrees, enter the setup menu,decimal blinks, press the Set subtract button to decimal places is set to 4, then press plus set the shift to the units digit and make it flashes, press the minus key make bits set to 3, then press plus, shift to the ten-digit flashing, press minus Set len—digit to 2, and finally press the function key to save)
2. Stop temperature value "S02" (set the same way as S01)
3. Tenmerature correction setting values ”SCl”, by setting the plus and minus settings into the settings, press the function key to complete
4. Start humidity settings "s03" (set the same way as S01)
5. Stop humidity value "S04" (set the same way as S01)
6. Set the humidity correction value "SC2", by setting the plus and minus settings into the settings, press the function key to complete
Set Example:
Note:
If the display "---" please check whether the sensor is open or damage the sensor, then the meter automatically starts protection function, the load is pawered off, You need to troubleshoot. After re-use only.